MicroNet™ Control Service Packs

9927-2659_-.exe

This Service Pack (9927-2659) is for the MicroNet CPU P1020 VxWorks control. The Service Pack will upgrade the 5418-7033 footprint to Revision D.

This release updates the S12X CAN peripheral to support 29 bit IDs for Custom CAN and the old generation Woodward ProAct product. It supports the MicroNet redundant system on-line changes (OLC) functionality. It updates the FPGA to fix a potential CPU hot swap issue and fixes a FPGA DPRAM data corruption issue when a read is performed from one side and a write occurs simultaneously from the other side at the same address.

System Requirements:

• Pentium® PC
• 32 MB of RAM
• Windows® 2000, XP, Vista, 7 or greater

Installation Instructions:

After downloading this file, you will install this service pack using AppManager from your desktop or laptop computer. For instructions on installing the service pack, refer to the AppManager help. AppManager Help is started under the Help menu.

Running the Service Pack:  The service pack installs the new firmware on the CPU. This takes approximately 9 minutes. DO NOT REBOOT OR POWER DOWN THE CPU DURING THIS PROCESS!  AppManager will prompt to reboot the CPU. Once the CPU is rebooted, the CPU will begin to install the new files.  The Status LED will flash green and yellow during this process.  The CPU will reboot on its own after this process has completed and the CPU will be visible with AppManager. The entire process takes approximately 15 minutes.