F-Series Service Tool


    The F-Series Service Tool is used to configure, adjust, monitor and troubleshoot an F-Series Control. The service tool runs on a personal computer and communicates with the F-Series Control through a serial connection. It requires the use of a RS232 to TTL converter. 

    Service Tool supports the following Control firmware part numbers:

    5418-9520 - (FSTP)
    5418-7290 A (ModAct)
    5418-7289 NEW, A(FSTP)
    5418-3834 NEW (FSTP)
    5418-3056 NEW,A (ModAct)
    5418-3055 NEW,A (FSTP)
    5418-2725 B,C,E (ModAct)
    5418-2724 B,C,E  (FSTP)

    System Requirements:

    • Microsoft Windows®  11, 10, 8.1, 7.
    • Microsoft .NET Framework version 4.7.2
    • Woodward ToolKit® version 7.0.1 or higher
    • 1 GHz or faster x86 or x64 processor
    • 1GB of RAM
    • Minimum 1024 by 768 pixel screen resolution
    • 9 pin-D Serial Port (RS232)
    • 9 pin-D straight through Serial Cable (not a null modem cable) 

    Service Tool requires that the Microsoft .NET Framework be installed. The Service Tool installation will attempt to install the .NET Framework from the Internet; but you can also obtain the .NET Framework Redistributable package from the link below.

    Click here for the .NET Framework Redistributable Package.

    Installation Instructions:

    1. The first step in installing this software is to download the file from this page. This file is an installation program that will step you through the installation process.
    2. After downloading this file, run it and follow the instructions on the setup dialogs.



    F-Series Service Tool
    27.9 MB