F-Series Service Tool


    The F-Series Service Tool is used to configure, adjust, monitor and troubleshoot an F-Series Control. The service tool runs on a personal computer and communicates with the F-Series Control through a serial connection. It requires the use of a RS232 to TTL converter. This service tool requires Woodward ToolKit v4.3 or newer.

    This version of the Service Tool is Windows XP compatible only. For Windows 7 and greater 9927-1874 rev. D should be installed.

    Version 4.40 supports the following Control firmware part numbers:

    5418-2724 (FSTP) Rev B, C, E
    5418-2725 (ModAct) Rev B, C, E
    5418-3834 (FSTP) Rev NEW
    5418-3055 (FSTP) Rev NEW, A
    5418-3056 (ModAct) Rev NEW, A

    System Requirements:

    • Microsoft Windows® XP SP3 (32- & 64-bit).
    • Microsoft .NET Framework ver. 4.0 & Hot Fix KB2592573
    • 1 GHz Pentium® CPU
    • 512 MB of RAM
    • Minimum 800 by 600 pixel screen with 256 colors
    • Recommended screen resolution 1024 x 768 or higher
    • 9 pin-D Serial Port (RS232)
    • 9 pin-D straight through Serial Cable (not a null modem cable)

    Installation Instructions:

    1. The first step in installing this software is to download the file from this page. This file is an installation program that will step you through the installation process.
    2. After downloading this file, run it and follow the instructions on the setup dialogs.



    F-Series Service Tool
    25.5 MB