ProTech Tools


    The ProTech® TPS Service Tool Software is used to configure, monitor and troubleshoot a ProTech® TPS Total Protection System (Safety PLC with Integrated Overspeed Protection).

    The ProTech® TPS Service tool supports the following firmware part numbers: 5418-7350 rev -,A (Math Enhancements), 5418-6348 rev NEW, A,B (Voted Inputs), 5418-6273 rev NEW,A, 5418-3630 rev A,B,C.

    System Requirements:

    • Microsoft Windows®  10, 8.1, 7.
    • Microsoft .NET Framework version 4.6.2 
    • Woodward ToolKit version 6.3.0 or newer
    • 1 GHz or faster x86 or x64 processor
    • 1GB of RAM
    • Minimum 1024 by 768 pixel screen resolution
    • 9 pin-D Serial Port (RS232)
    • 9 pin-D straight through Serial Cable (not a null modem cable)
    Service Tool requires that the Microsoft .NET Framework be installed. The Service Tool installation will attempt to install the .NET Framework from the Internet; but you can also obtain the .NET Framework Redistributable package from the link below.

    Click here for the .NET Framework Redistributable Package.

    Installation Instructions:

    1. The first step in installing this software is to download the file from this page. This file is an installation program that will step you through the installation process.
    2. After downloading this file, run it and follow the instructions on the setup dialogs.



    ProTech Tools
    32 MB