Woodward’s DTSC-50 digital transfer switch controller is an economical controller for open-transition (break before make) ATS (automatic transfer switch) control for emergency stand-by applications with a single generator. When the DTSC-50 detects a utility failure, it commands the generator to start and transfers the load to the emergency source. The DTSC-50 performs an open-transition re-transfer when utility power is restored, allowing the engine to cool down before stopping. It can be utilized in 1Ph2W, 1Ph3W, 3Ph3W, and 3Ph4W systems.DTSC-50 ›
Automatic Transfer Switch Controllers
Load Transfer With Confidence
Woodward’s ATS (automatic transfer switch) controllers help you reduce complexity in terms of hardware, spacing, and component cost for new builds and retrofits. This is feasible, because our configurable software allows these applications to run from one controller:
This also includes delayed and closed transition modes, among other typical ATS-specific features. By using Woodward products, you can handle all ATS-relevant features by ordering one single device, which provides maximum value for your ATS application. For more simple applications, Woodward provides a basic version of an ATS controller.
Woodward’s DTSC-200 is the ultimate control for new ATS (automatic transfer switch) builds and retrofits. A complete measurement and protection package, it easily configures to Utility-to-Generator, Generator-to-Generator, or Utility-to-Utility systems for open, delayed, or closed-transition transfer with synch-check to ensure the smoothest possible transfer.DTSC-200 ›